HOSE AS 4592094 - Caterpillar

Illustration 12 g01408052
Remove bearing cup (33) and shims (34) (not shown).
Illustration 13 g01407602
Remove piston (38) and piston (39) from housing (35) .
Remove port plate (36) from housing (35) .
Remove barrel assembly (37) (not shown) from housing (35) .
Illustration 14 g01407631
Remove O-ring seal (40) from piston (38) . Repeat this step for the other piston.
Illustration 15 g01407641
Remove rod (41) from swashplate assembly (42) .
Illustration 16 g01407684
Use Tooling (C) and a suitable press in order to remove race (44) and bearing cone (45) from shaft (43) .
Illustration 17 g01408079
Remove swashplate assembly (42) from shaft (43) .Note: Note the position of each piston to the barrel for assembly purposes.
Illustration 18 g01408091
Use a suitable press in order to remove bearing cone (46) from shaft (43) . Remove shaft (43) from barrel assembly (37) .
Illustration 19 g01408107
Remove special washer (47) from barrel assembly (37) .
Illustration 20 g01408159
Illustration 21 g01408179
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Use Tooling (D) and a suitable press in order to apply slight compression to barrel assembly (37) . Use Tooling (E) in order to remove retaining ring (48) from barrel assembly (37) .Note: Note the orientation of the white mark on retaining ring (48) for assembly purposes.
Remove shims (53) , washer (52) , spring (51) , and washer (50) from barrel (49) .
Illustration 22 g01408121
Illustration 23 g01408122
Remove screws (63) , plate (58) , plate (62) , shims (57) , shims (61) , sleeves (55) , and sleeves (60) from swashplate assembly (42) . Remove washer (56) and pistons (59) from swashplate (54) .Note: Note the orientation of washer (56) for assembly purposes.
Illustration 24 g01408511
Use Tooling (E) in order to remove retaining ring (64) from housing (35) . Remove seal (65) from housing (35) .
Remove bearing cup (66) from housing (35) . Remove cradle bearings (68) from housing (35) . If necessary, remove pins (67) from housing (35) .