AVSPARE.COM
parts catalog

HOSE AS 4622626 - Caterpillar


4622626 HOSE AS Caterpillar parts
Rating:
71
Alternative (cross code) number:
CA4622626
462-2626
4622626
Caterpillar 4622626 HOSE AS

Buy HOSE AS 4622626 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 8
  For full view, you need register

Information:


Illustration 1 g00577806
Schematic Of The Left Front Raise SolenoidThis diagnostic code is recorded when the ECM determines that a diagnostic code that is internal to the ECM exists. The left front raise solenoid circuit of the machine harness consists of the following components:
The energize signal is wire C751-OR (J1-10).
The return signal is wire K927-BU (J1-7). The possible causes of this diagnostic code are listed here:
The ECM is faulty. There are no serviceable parts within the ECM. The system response to this level three diagnostic code is listed below:
The diagnostic code indicator flashes.
The alarm beeps.
The readouts show the word "FAULT".
The elevation of the machine cannot be changed.
Verify The Diagnostic Code.
Turn the key start switch and the grade/slope switch to the OFF position.
Disconnect the J1 and J2 machine harness connectors from the ECM.
Clean the contacts of the J1 and J2 machine harness connectors.
Reconnect all harness connections.
Turn the key start switch and the grade/slope switch to the ON position.
Enter service mode and clear all inactive diagnostic codes.
Enter operating mode. Then, briefly operate the machine.
Enter service mode. Check whether the CID 0900 FMI 12 diagnostic code is present. The diagnostic code indicator would be FLASHING. Expected Result: The CID 0900 FMI 12 diagnostic code should not be present. The diagnostic code indicator should be OFF.Results:
OK - The diagnostic code is not present. The diagnostic code does not exist at this time. The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation. STOP.
NOT OK - The diagnostic code is present. The diagnostic code has not been corrected. Replace the ECM. See Testing And Adjusting, "Electronic Control Module - Replace". STOP.

Caterpillar parts catalog:

Caterpillar parts catalog
910M Compact Wheel Loader H2200001-UP (MACHINE) POWERED BY C4.4 Engine
910K Compact Wheel Loader L2200001-UP (MACHINE) POWERED BY C4.4 Engine
914M Compact Wheel Loader H2400001-UP (MACHINE) POWERED BY C4.4 Engine
914K Compact Wheel Loader L2400001-UP (MACHINE) POWERED BY C4.4 Engine
914K Compact Wheel Loader BF400001-UP (MACHINE) POWERED BY C4.4B Engine


Parts hose Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.