HOSE AS 4696114 - Caterpillar

EMCP 4
Start the engine by one of the following methods.
The operator presses the "RUN" Key.
Activate the Digital Input programmed for ECS in Run.
Place the control in Auto mode.If starting the engine using auto mode, use one of the following methods.
Activate the Remote Start Input.
Activate a Remote Initiate over the MODBUS data link (EMCP 4.2/4.3/4.4 only).
Configure a Programmable Cycle Timer (EMCP 4.2/4.3/4.4 only).
The EMCP 4 checks the system before the crank cycle begins. The EMCP 4 checks that no system faults are present. The EMCP 4 checks that all previous shutdown faults have been reset. The EMCP 4 also checks that the engine is not already running. If the engine is equipped with prelube, the EMCP 4 checks the status of the prelube. If the prelube is not complete, the EMCP 4 will not crank the engine.
The EMCP 4 begins the crank cycle.
The EMCP 4 cranks the engine until the crank cycle time reaches the setpoint for total crank time or until the engine starts.
The EMCP 4 deactivates the starting motor relay (SMR) when the engine speed reaches the setpoint for crank terminate speed.