HOSE AS 4807782 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-9612 Silicone Sealant 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Apply Tooling (A) to the bottom of the rear housing at the junction of the cylinder block and the engine oil pan.
Illustration 1 g01147138
Illustration 2 g01147149
Attach a suitable lifting device to rear housing (4). The weight of rear housing (4) is approximately 84 kg (185 lb).
Position the gasket on rear housing (4).
Position rear housing (4) on the cylinder block. Install bolts (3). Tighten bolts (3) in a numerical sequence to a torque of 55 10 N m (41 7 lb ft).
Trim the gasket between the rear housing and the cylinder block even with the bottom of the rear housing.
Illustration 3 g01147132
Install bolts (2).
Connect hose assembly (1).
Install the bolts that hold the engine oil pan to the rear housing.
Tighten all the bolts that hold the engine oil pan evenly in order to raise the engine oil pan into position. End By:
Install the rear gear group. Refer to Disassembly and Assembly, "Gear Group (Rear) - Install".