HOSE AS 4923474 - Caterpillar

Probable Causes
Programmable parameters
Problem with a switch
Clutch switch or clutch spring
Electrical power to the Engine Control Module (ECM)Recommended Actions
Note: If a kickout occurred, the ECM stores the most recent cause of the kickout. However, the ECM will not store the information if the ECM is powered down. The ECM is powered down when the keyswitch is placed in the OFF position. It may be necessary to operate the vehicle in order to duplicate the problem. Then, check the value of the "Cruise Kickout", the "Idle Kickout", or the "PTO Kickout" status parameter before the ECM is powered down.Perform the actions that relate to the feature that has the complaint.Check the Programmable Parameters
Refer to Table 1. Use the Caterpillar Electronic Technician (ET) to verify that configuration parameters for the feature with the complaint are programmed correctly:
Table 1
Parameters for the Features
Feature Configuration Parameters Notes
Cruise Control Low Cruise Control Set Speed Limit If the vehicle speed is below the "Low Cruise Control Set Speed Limit", the cruise control can not be set or resumed.
High Cruise Control Set Speed Limit If the vehicle speed exceeds the "High Cruise Control Set Speed Limit" and the driver attempts to set a cruise control speed, the cruise set speed will be the "High Cruise Control Set Speed Limit".
Transmission Neutral Switch
Cruise Control On/Off Switch
Cruise Control Set/Resume/Accel/Decel Switch
Cruise Control Pause Switch
Extended Idle Idle Vehicle Speed Limit If the driver attempts to set an idle engine rpm and the vehicle speed exceeds the "Idle Vehicle Speed Limit", the idle will not activate.
Idle RPM Limit If the engine rpm is above the "Idle RPM Limit" and the driver attempts to set an idle engine rpm, the idle engine rpm will be the idle rpm limit.
Transmission Neutral Switch
Cruise Control On/Off Switch
Cruise Control Set/Resume/Accel/Decel Switch
Cruise Control Pause Switch
PTO PTO Top Engine Limit
PTO Kickout Vehicle Speed Limit If the vehicle speed exceeds the programmed "PTO Kickout Vehicle Speed Limit", the ECM will not maintain the set speed.
Transmission Neutral Switch
PTO On/Off Switch
Remote PTO Set Switch
Remote PTO Resume Switch Check the Switches
Typically, the operation of the PTO requires an interlock switch such as a parking brake switch. Ensure that all interlocks are set to allow PTO operation.Cat ET uses the following status parameters to display the most recent cause of the rubbing: "Cruise Kickout", "Idle Kickout" and "PTO Kickout". Check the cause of the kick out.If the cause of the kick out is "Switch Turned Off", the ECM has detected an open circuit in the circuit for the cruise switch or the PTO switch. Verify that the operator did not turn off the switch. Use Cat ET