HOSE AS 4E5411 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7574     Link Bracket     4    
B     1U-9200     Lever Puller Hoist     2    
C     140-7742     Protective Sleeve     2    Note: Cleanliness is an important factor. Before the installation procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g03728692
Use Tooling (A) , (B) and (C) and a suitable lifting device in order to install center axle (8) . The weight of center axle (8) is approximately 1285 kg (2833 lb).
Illustration 2 g01188874
Use two people in order to position stabilizer bracket (11) . The weight of stabilizer bracket (11) is approximately 25 kg (55 lb).
Install bolts (10) and install bolts (9) . Tighten bolts (10) to a torque of 900 100 N m (664 74 lb ft) and tighten bolts (9) to a torque of 270 40 N m (199 30 lb ft).
Illustration 3 g01189012
Install bolts (7) and install bolts (6) . Tighten bolts (7) to a torque of 900 100 N m (664 74 lb ft) and tighten bolts (6) to a torque of 270 40 N m (199 30 lb ft).
Illustration 4 g01188872
Connect hose assembly (5) and connect hose assembly (3) .
Install bolt (4) .
Illustration 5 g01188871
Connect hose assembly (2) and connect hose assembly (1) .
Fill the axle housing with fluid to the proper level. Refer to Operation and Maintenance Manual, "Differential and Final Drive Oil - Change".End By:
Install the center tires and rims. Refer to Disassembly and Assembly, "Tire and Rim - Remove and install".
Install the stabilizer rod for the center axle. Refer to Disassembly and Assembly, "Center Axle Stabilizer Rod - Remove and Install".
Install the center drive shaft. Refer to Disassembly and Assembly, "Center Drive Shaft - Remove and Install".
Purge the air out of the braking system. Refer to Systems Operation, Testing and Adjusting, "Service Brake Air - Purge".