HOSE-AFTERCOOLER 5024193 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Attach a suitable lifting device to the oil cooler. For 3508B Engines, the weight of the oil cooler is approximately 45 kg (100 lb). For 3512B Engines, the weight of the oil cooler is approximately 65 kg (143 lb). For 3516B Engines, the weight of the oil cooler is approximately 78 kg (172 lb).
Illustration 1 g01057407
Lubricate the bore for the O-ring at Point (X) with clean engine oil. Install the seal. Install a new gasket for flange (6). Lift the oil cooler into position on the engine. Point (X) is a slip fit. Install the bolts for flange (6).
Illustration 2 g00747911
Install bolts (5) at the bottom of the oil cooler. The bolts are directly above the fuel transfer pump.
Illustration 3 g00747906
Install bolts (4).
Illustration 4 g00603770
Install a new gasket for the joint between the elbow and the cylinder block. Use glycerin to lubricate the new O-ring seal for the slip fit of tube (3). Fit tube (3) into the bonnet of the oil cooler. Install bolts (2).
Connect the hose (not shown) of connection (1) for the jacket water heater.
Fill the cooling system with coolant. Refer to the Operation and Maintenance Manual, "Refill Capacities".