HOSE AS 5105314 - Caterpillar

Illustration 1 g02743397
Install O-ring seal (14) and spacer (15) onto piston motor (9).Note: The chamfered side of spacer (15) should face piston motor (9).
Illustration 2 g01326516
Illustration 3 g02741657
Position Tooling (B) and Tooling (F) on each side of the machine. Position Tooling (C), Tooling (D), and Tooling (E) onto Tooling (C) and (F). Attach piston motor (9) to Tooling (E). The weight of piston motor (9) is approximately 50 kg (110 lb).
Illustration 4 g02741677
Illustration 5 g01326527
Position piston motor (9) and loosely install bolts (10). Install sprocket (13). Install retainer (12) and bolt (11).Note: The piston motor and the sprockets should be installed at the same time. The inside sprocket will align with the rear driven sprocket and the outside sprocket will align with the front driven sprocket.
Illustration 6 g06011768
Tighten bolts (10).
If bolts (10) are HEX head bolts, tighten to a torque of 40 3 N m (30 2 lb ft) in the sequence shown. Tighten bolts (10) to a final torque of 170 +15/ - 0 N m (125 + 11/ - 0 lb ft) in the sequence shown.
If bolts (10) are 12 point head bolts, tighten to a torque of 40 3 N m (30 2 lb ft) in the sequence shown. Tighten bolts (10) to a final torque of 190 + 15/ - 0N m (140 + 11/ - 0 lb ft) in the sequence shown.
Illustration 7 g02741476
Connect hose assemblies (7) and hose assembly (8).
Illustration 8 g01326496
Tighten bolts (6).
Adjust the chain tension. Refer to Operation and Maintenance Manual, "Drive Chain Tension - Check/Adjust".
Illustration 9 g01326401
Use Tooling (A) to raise the side machine. Remove the blocking and lower the machine. Repeat for the rear of the machine.
Illustration 10 g01326399
Apply a continuous bead of Tooling (G) to the mating surface of plate (5). Install plate (5) and bolts (4).
Fill the drive chain case. Refer to Operation and Maintenance Manual, "Drive Chain Case Oil - Change".
Illustration 11 g01326382
Position plate assembly (3) and install bolts (2). Tighten bolts (2) to a torque of 25 5 N m (220 44 lb in).
If equipped, install the air conditioner and heater.
Lower the cab.
Illustration 12 g01322019
Raise the lift arms and remove cylinder lock (1).