HOSE AS 5125850 - Caterpillar

Automatic Engine Speed Control (AEC) will increase engine speed automatically when you operate the control levers and/or travel pedals with AEC switch on.When loading and unloading the machine from the truck or working in close quarters always turn AEC switch off to prevent any possibility of sudden movement of machine, which could result in serious injury or death.Set the travel speed control switch to LOW before loading the machine. Never operate this switch when loading the machine on a trailer.
Investigate overpass clearances on the travel route. Make sure that there will be adequate clearance for the machine.Remove ice, snow, or other slippery material from the loading dock and from the truck bed before you load the machine onto the transport machine. Removing ice, snow, or other slippery material will help prevent the machine from slipping in transit.Note: Obey all laws that govern the characteristics of a load (height, weight, width, and length). Observe all regulations that govern wide loads.Choose the flattest ground when you load the machine or when you unload the machine.
Before you load the machine, chock the trailer wheels or the rail car wheels.
When you use loading ramps, make sure that the loading ramps have adequate length, adequate width, adequate strength, and an adequate slope.
Maintain the slope of the loading ramps within 15 degrees of the ground.
Position the machine so that the machine can drive straight up the loading ramps. The final drives should be toward the rear of the machine. Do not operate the control levers while the machine is on the loading ramps.
When you drive over the loading ramp joint areas, maintain the balance point of the machine.
Lower the work tool to the bed or to the floor of the transport machine.
To prevent rolling of the machine or sudden movement of the machine, perform the following items:
Chock both tracks.
Install sufficient tie-downs at several locations.
Fasten wire cables.Note: Refer to Operation and Maintenance Manual, "Specifications". Refer to Operation and Maintenance Manual, "Lifting and Tying Down the Machine".