HOSE AS 5230918 - Caterpillar

- REWORK PROCEDURE1-Disconnect positive wire on battery.2-Open the dashboard cover.Plug the relay item 2. Please see electrical schematic on service manual KENR2630. 3- Close dashboard cover.4- Pick up the electrical harness located on the machine in the area A, behind the rear working light.If necessary, remove control handle B, platform C, and water tank D (tightened by a strap).NB: the electrical harness is composed of 2 electrical wires (purple and black 700 in yellow braid. 5- In case of, re-install the water tank D, the platform C and the control handle B.6- Then remove the shunting located at the end of the electrical harness from area A.7- Install guide item 3 on the electrical harness of the seat switch.8- Push the seat in maximum rear position. lnstall seat switch item 1 and guide item 3 into the seat. 9- Plug the seat switch item 1 on machine electrical harness from area A (yellow braid).Please see seat sw on electrical schematic.10- Re-connect positive wire on battery.11- Run a test: when parking brake is released and propel lever is in neutral position:If propel lever is moved forward while the operator is not seated, the machine must not move.If propel lever is moved forward while the operator is seated, the machine must move.12- Install the decal 4. COPYRIGHT 1995 CATERPILLAR ALL RIGHTS RESERVED