HOSE AS (SEM) 5238479 - Caterpillar

If equipped with an air inlet heater (AIH) for cold weather starting, do not use aerosal types of starting aids such as ether. Such use could result in an explosion and personal injury.
To prevent personal injury, be sure all personnel are clear of the machine. Sound the horn for several seconds before starting the engine.
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again.Turbocharger damage can result, if the engine rpm is not kept low until the engine oil pressure indicator goes out, verifying the engine oil pressure is sufficient.Key must be in run position with engine running to maintain electrical and hydraulic functions and prevent serious machine damage.If the engine does not start, return the key to OFF before returning it to START.
Illustration 1 g00572661
Open the access door on the right side of the machine. Turn the battery disconnect switch to the ON position.
Illustration 2 g00572618
The following conditions must be met in order to start the machine.
Push down the parking brake knob (1) in order to apply the parking brake.
Move the propel control lever (2) to the STOP position.
Move the vibration switch (3) to the OFF position.
Move the water spray switch (4) to the OFF position.
Illustration 3 g00592071
Move the throttle control switch (5) to the FAST position.
Turn the ignition switch (6) to the ON position.
Do not push the air inlet heater switch for more than 30 seconds without attempting to start the engine. Allow the inlet heater 60 seconds to cooldown if the engine is not cranked.
Push the air inlet heater switch (7) for at least 10 seconds and up to a maximum of 30 seconds. This depends on the outside air temperature.
In order to crank the engine, turn key (6) to the START position. When the engine starts, release the key.Note: When you are cranking the engine, and warming the engine up the air inlet heater can be used, as needed. This will help reduce misfire and white smoke during start-up.
Push the throttle control switch (5) to the SLOW position after you start the engine.