HOSE AS 5269195 - Caterpillar

Testing Procedure for Fixed Frequency in Low Amplitude
Move vibratory amplitude control (2) to the LOW AMPLITUDE position.
Start the machine and run the engine at 2310 50 RPM. Check the hydraulic temperature with Tool (B) until the hydraulic oil temperature reaches 38°C (100°F).
Depress vibratory on/off control switch (1) to the ON position in order to start the vibratory system. Place Tool (A) on the drum. Read the vibrations per minute (VPM) from Tool (A) . The maximum VPM setting for low amplitude for the CS/CP-563E and the CS-573E should be 1965 50 VPM. The maximum VPM setting for low amplitude for the CS-583E should be 1850 + 50 - 100 VPM.Adjusting Procedures for Fixed Frequency in Low Amplitude
Illustration 5 g00935144
Frequency Adjustment (6) Vibratory pump (7) Low amplitude adjustment screw
If the frequency is not correct, adjust low amplitude adjustment screw (7) . Loosen the locknut on adjustment screw (7) . Turn the adjustment screw counterclockwise in order to increase maximum VPM. Turn adjustment screw clockwise in order to decrease maximum VPM.
Depress vibratory on/off control switch (1) to the OFF position in order to stop the vibratory system. Testing Procedure for Variable Frequency in High Amplitude (Minimum Frequency)
Place the vibratory amplitude control (2) in the HIGH AMPLITUDE position.
Turn variable vibration control knob (3) to the full counterclockwise position.
Illustration 6 g00928223
Control Console (1) Vibratory ON/OFF switch (2) Vibratory amplitude control (3) Variable vibration control knob
Start the machine and run the engine at 2310 50 RPM. Check the hydraulic temperature with Tool (B) until the hydraulic oil temperature reaches 38°C (100°F).
Depress vibratory on/off control switch (1) in order to start the vibratory system. Place Tool (1) on the drum. Read the vibrations per minute (VPM) from Tool (A) . The minimum frequency for high amplitude should be 1400 50 VPM.
Depress the vibratory ON/OFF switch (1) in order to shut off the vibratory system.Note: Refer to Testing and Adjusting, "Vibratory Tachometer - Adjust" if the vibration tachometer is installed and