HOSE AS 5288608 - Caterpillar

Illustration 7 g01074233
Position tube (21) on cover (11).
Illustration 8 g01074234
Install shim (25) on tube (21).
Illustration 9 g01074236
Install retainer (24) on tube (21).
Illustration 10 g01073590
Install pistons (23) in guide (22).
Illustration 11 g01074237
Install pistons (23) in cylinder block (26).
Illustration 12 g01074238
Position plate (19) on tube (21).
Illustration 13 g01074246
Install gasket (20) on cover (11).
Illustration 14 g01073583
Position housing (3) on cover (11) and install two bolts (13).
Illustration 15 g01073579
Raise the temperature of bearing (9). Install bearing (9) on shaft (7). Use Tooling (B) and install retaining ring (8) on shaft (7).
Illustration 16 g01074306
Install shaft (7) in housing (3).
Illustration 17 g01073572
Use Tooling (A) and a suitable press to install lip seal (5) in cover (2).
Install O-ring seal (6) on cover (2).
Illustration 18 g01074308
Install cover (2) and bolts (1).
Install O-ring seal (4) on housing (3).
Illustration 19 g01073724
Install O-ring seal (18) on speed sensor (14).
Illustration 20 g01074327
Illustration 21 g06265394
Install four bolts (10) and bolt (12) that fastens cover (11) to housing (3).
Turn in speed sensor (14) by hand until bottom end gently touches the speed ring.
Back out speed sensor (14) 1/4 turn. Continue backing out until the flats are 22 degrees either side of motor shaft center line. Do not back out the speed sensor more than 3/4 of a turn from touching.
Hold the speed sensor from turning, tighten the lock nut to a torque of 13 N m (115 lb in).
Install bracket (16) and bolt (17).End By:
Install the propel motor. Refer to Disassembly and Assembly, "Piston Motor (Propel) - Install".