HOSE 5350557 - Caterpillar

*These tools are part of 6V3180 Sprocket Tool Arrangement.start by:a) remove final drive cases, gears, idler pinions and bearings 1. Remove ring (1) and the pin from nut (2).
Do not remove nut (2) from the sprocket shaft.
2. Loosen nut (2) with tool (A) until there is a clearance of 3.2 mm (.125 in.) between the nut and the steering clutch case.3. Install tooling (B) and remove sprocket shaft as follows: a) Install 5P5215 Adapter (3) on sprocket shaft (4) until all the threads are engaged. b) Install 5P5207 Stud (5) in adapter (3) and turn it all the way into the adapter. Install sleeve (7) with (slot) opening (8) away from the bevel gear case as shown.c) Put 5S1430 Sleeve (7) over stud (5) until the sleeve makes contact with bevel gear case (9). d) Install 9H3992 Head (6) (or 7F5283 head) over stud (5) and into the end of sleeve (7).e) Put 5P5201 Cylinder (11) on stud (5) and against head (6). Install nut (10). Connect the 5P3100 Pump Group to the cylinder.f) Hold sleeve (7) and head (6) in alignment and put enough force on the sprocket shaft to loosen the sprocket shaft from the taper.
Be sure the piston of cylinder (11) is retracted before the tooling is removed.
g) Remove tooling (B). Fasten a hoist to the sprocket shaft. Remove nut (2). Remove the sprocket shaft. The weight is approximately 84 kg (185 lb.).Install Sprocket Shafts
Typical Example1. Fasten a hoist to the sprocket shaft and put it in position in the steering clutch case. Push the shaft in the case as far as possible by hand.
Be sure the threads in the bevel gear case are not damaged. Install the 1P3054 Adapters in the bevel gear case so the shoulder of the adapter is against the bevel gear case. After the shoulder of the 1P3054 Adapter comes in contact with the bevel gear case, the adapters can be tightened a maximum of 1/8 turn or loosened a maximum of 3/8 turn to put the adapter in the correct position so the remainder of tooling (A) can be installed. When the remainder of tooling (A) is installed, do not let the weight of the tooling or hoist put a load on the 1P3054 Adapters. Keep tooling (A) level.
2. Fasten tooling (A) to sprocket shaft (1) as shown.3. Install the sprocket shaft with a force of 490 to 535 kN (55 to 60 ton). Install nut (4) on the end of the shaft and tighten the nut to a torque of 1020 70 N m (750 50 lb.ft.) with tool (B) while the force is still on the shaft. Release the pressure on tooling (A).4. Measure distance (C) from the inner edge of the holder assembly to the bottom of the counterbore for the inner bearing cup. This dimension must be 43.84 0.16 cm (17.258 .062 in.).5. Fasten nut (4) in position as follows:a) Make a 9.35 mm (.368 in.) hole in one of the