HOSE AS 5369711 - Caterpillar

Assembly Procedure
Illustration 1 g00587055
Install ring (15) and O-ring seal (3) .
Install seal ring (13) on piston (1), as shown. Put clean oil on the seal ring.
Install seal ring (7) on retainer (8), as shown.Note: Make sure that the oil port in retainer (8) is aligned with O-ring seal (3) .
Position spring (2), piston (1), and retainer (8). Install six bolts (10). Tighten the bolts evenly in order to compress the spring behind the retainer and behind the piston.
Install thrust washer (14) .
If ring (11) was removed, install the ring.
Install disc (4) and a plate. Continue to install the three remaining discs and the plates in an alternating order. Install hub (9) .
Install thrust washer (6) in retainer (5) .
Position retainer (5). Install three bolts (12) and the washers.End By: Install the final drive on the left side of the machine. Refer to Disassembly and Assembly, "Final Drive - Install" in this module.