HOSE AS 5584492 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the implement hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Release hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release" in this manual. Note: Put plugs in the ends of the hoses in order to keep dirt and debris out of the hydraulic system. Put identification marks on all of the hoses and lines for assembly purposes.
Illustration 1 g00537321
Disconnect hose assembly (1) and hose assembly (5) from the pilot pump (3).
Remove two socket head bolts (2) that hold pilot pump (3) mounted in place. Remove the pilot pump.
Illustration 2 g00536943
Remove O-ring seal (4) from the pilot pump.