HOSE AS 5N6056 - Caterpillar

Start By:a. remove steering clutches 1. Remove brake band (2) and outer drum (1) from the steering clutch. 2. Install tooling (B) to the end of the clutch shaft and install it in a vise.3. Remove lock (3). Use tooling (A) and loosen nut (4) until it is even with the top of the shaft.
Do not remove nut (4). This will keep the drum on the shaft when it is loosened from the taper on the shaft.
4. Remove the steering clutch from the vise. The weight is approximately 45 kg (100 lb).5. Use tooling (D) as shown to push the shaft from the inner drum. Remove tooling (D) and nut (4). Remove the shaft from the steering clutch. 6. Install tooling (H) on the other side of the steering clutch and install it in a vise.7. Remove two setscrews (5). Use tool (E) and remove spanner nut (6) from the plate assembly. 8. Bend locks (7) down and remove bolts (8) that hold the yoke in place.9. Remove yoke (9) from the plate assembly. 10. Use a pry bar on each side of the bearing cage and remove