HOSE 5W7098 - Caterpillar

1. Disconnect fuel lines (1) and (2). Plug and cap all openings to prevent debris and contamination from entering the system.2. Loosen the Allen screws from connectors (4) and (5) on electronic control module (3). Disconnect connectors (4) and (5).3. Remove bolts (6) from electronic control module (3).4. Remove electronic control module (3).
To avoid component damage, use the allen screws to pull the mating parts of connectors (4) and (5) together. Ensure that the connectors are properly aligned and seated before installing the allen screws. Do not over tighten the allen screws. Excessive torque will cause component damage. Tighten the allen screws holding connectors (4) and (5) to a torque of 2.25 0.25 N m (20.0 2.0 lb in).
5. Install the electronic control module in the reverse order of removal.