HOSE AS 6T5088 - Caterpillar

Illustration 1 g03344056
Schematic of the pressure sensor (fixed displacement pump oil)Sales model 854G/992GThis diagnostic code is associated with the fixed displacement pump oil pressure sensor. The FMI 03 means that the ECM has determined that the voltage of the circuit for the sensor is above normal. The sensor is a PWM sensor that operates at a frequency of approximately 500 Hz. The sensor sends a PWM input signal (duty cycle) to the ECM. The duty cycle of the signal changes as the pressure changes.The possible causes of this diagnostic code are listed below:
The signal circuit for the sensor is open.
The signal circuit for the sensor is shorted to the +battery circuit.
The sensor has failed.
The power circuit or the ground circuit has failed.
The ECM has failed. ECM failure is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0767 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK FOR POWER AT THE SENSOR
Do not disconnect the harness connector from the sensor.
Turn the key start switch and the disconnect switch to the ON position.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the voltage supply wire (contact A).
Measure the voltage from contact A to frame ground. Expected Result:The voltage is approximately 24 DCV (+ battery circuit). Note: The sensor operating range is between 8 V to 32 V.Results:
OK - The voltage is correct. Proceed to Test Step 2.
NOT OK - The voltage is not correct. The + battery circuit in the machine harness has failed. Repair: Replace the machine harness or repair the machine harness. STOPTest Step 2. CHECK FOR PROPER GROUND AT THE SENSOR
The machine harness remains connected to the sensor.
Turn the key start switch and the disconnect switch to the OFF position.
Remove the 7X-1710 Multimeter Probe from the voltage supply wire (contact A).
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the ground wire (contact B).
Measure the resistance from contact B to frame ground. Expected Result:The resistance is less than 5 ohms. Results:
OK - The resistance is less than 5 ohms. The ground circuit is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5 ohms. The ground circuit in the machine harness has failed. Repair: Replace the machine harness or repair the machine harness. STOPTest Step 3. CHECK THE WIRING HARNESS OF THE SENSOR FOR AN OPEN CIRCUIT
The key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness from the sensor.
At the harness connector for the sensor, connect a jumper wire between contact B and contact C.
Disconnect the machine harness connectors from the ECM.
At the harness connector for the ECM, measure the resistance between contact J1-10 (wire M912-BU) and contact J2-19 (wire J842-BK). Expected Result:The