HOSE AS 6Y4067 - Caterpillar

Installation Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g01348471
Ensure that filter base (4) is clean. Clean the mating surfaces of the cylinder block.
Install a new gasket to filter base (4). Position filter base (4) on the cylinder block.
Install bolts (3). Tighten bolts (3) to a torque of 22 N m (16 lb ft).
Install engine oil filter (5). Refer to Operation and Maintenance Manual, "Engine Oil Filter - Change".
If necessary, install engine oil pressure sensor (1). Tighten engine oil pressure sensor (1) to a torque of 10 N m (89 lb in).
Connect harness assembly (2) .
Check oil level. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check".End By: Install the engine side guard. Refer to Disassembly and Assembly, "Engine Side Guards - Remove and Install".