HOSE AS 6Y4076 - Caterpillar

Ether Solenoid Configuration
The parameter for the "Ether Solenoid Configuration" allows the ether solenoid to be Installed or Not Installed.Top Engine Limit
This parameter is the maximum engine rpm when the engine is under load. The engine will still achieve top engine speed under no load conditions.Injector Trim File
This parameter is for the injector trim files that are associated with each injector. If an injector is replaced or if two injectors are exchanged between cylinders, the injector trim file for the injector must be programmed to the correct cylinder.Parameter Table
Table 2
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
ECM Identification Parameters    
Equipment ID     17 alphanumeric characters     Blank     None    
Engine Serial Number     0XX00000 or XXX00000     Blank     Factory    
ECM Part Number     Hardware Dependent     Blank     Read Only (1)    
ECM Serial Number     Hardware Dependent     Blank     Read Only (1)    
Software Group Part Number     Software Dependent     Read Only (1)    
Software Group Release Date     Software Dependent     Read Only (1)    
Software Group Description     Software Dependent     Read Only (1)    
System Parameters    
Rating Number     1 or 2     1     Read Only (1)    
Rated Power     Software Dependent     Read Only (1)    
Rated Peak Torque     Software Dependent     Read Only (1)    
Top Engine Speed Range     Software Dependent     Read Only (1)    
Test Spec     Software Dependent     Read Only (1)    
FLS     Programmed at the Factory     Factory    
FTS     Programmed at the Factory     Factory    
Total Tattletale     0 to 65535     0     Read Only (1)    
Engine Configuration Parameters    
Low System Battery Voltage Elevated Idle     Disabled
Enabled     Enabled     None    
Ether Solenoid Configuration     Not Installed
Continuous Flow Solenoid     Continuous Flow Solenoid     None    
Configuration Group 1    
Top Engine Limit     Software Dependent     Read Only (1)    
( 1 ) This parameter can be viewed only. No changes are allowed.Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 3
Information from ECM    
Equipment ID    
   
Engine Serial Number    
   
ECM Part Number    
   
ECM Serial Number    
   
Software Group Part Number    
   
Software Group Release Date    
   
Software Group Description    
   
Rating Number    
   
Rated Power    
   
Rated Peak Torque    
   
Top Engine Speed Range    
   
Test Spec    
   
FLS    
   
FTS    
   
Total Tattletale    
   
Low System Battery Voltage Elevated Idle    
   
Ether Solenoid Configuration    
   
Top Engine Limit    
   
Information From Engine Information Plate    
Engine Serial Number    
   
Full Load Setting
(for new ECM)    
   
Full Torque Setting
(for new ECM)    
   
Injector Code (1)    
   
Injector Code (2)    
   
Injector Code (3)    
   
Injector Code (4)    
   
Injector Code (5)    
   
Injector Code (6)