HOSE A 7I1208 - Caterpillar

Illustration 119 g03675054
Assemble the end of hose assembly (150) with the 45 degree bend to the back elbow (142) that was installed in Step 269. Route the hose assembly over the hoist valve to the top port on tee (120). Assemble the hose assembly to the tee.
Install one clip (151) around both hose assemblies near plate assembly (123). Use one bolt (64), and one hard washer (42) to secure the clip to the plate assembly.
Go to the right side of the hoist valve. Assembly one clip (151) around both hose assemblies. Remove the upper right bolt and washer on the half flange. Align the hole in the clip with the hole on the half flange. Use the bolt and washer to secure the clip to the half flange.
Illustration 120 g03675078
Four bolts (KB), the four washers (KC), and the two half flanges (KD) were saved in Step 102. Retrieve the parts.
Go to the lift cylinder on the left side of the machine.
Install one rectangular seal (55) into the end of hose assembly (152) with the 90 degree bend. Use the four bolts (KB), the four washers (KC), and the two half flanges (KD) to secure the hose assembly to the lift cylinder. Route the hose assembly to the hoist valve.
Hose assembly (152) will pass near bracket assembly (141) that was installed earlier. Assemble one grommet (153) around the hose assembly near the bracket assembly. Assemble one clip (154), and one clip (155) around the grommet. Use two bolts (97), and two hard washers (26) to secure the clips to the bracket assembly.
Illustration 121 g03675104
Route hose assembly (152) to the right side of the hoist valve as shown. Install one rectangular seal (156) into the end of the hose assembly. Use four bolts (157),four washers (158), and two half flanges (159) to secure the hose assembly to the hoist valve.
Go to the center of the hoist valve where hose assembly (152) passes near plate assembly (123). Install one grommet (153) around the hose assembly near the plate assembly. Assemble one clip (154), and one clip (155) around the grommet. Use two bolts (71), and two hard washers (42) to secure the clips to the plate assembly.
Illustration 122 g03675122
Install one rectangular seal (156) into the one end of