HOSE 8V3070 - Caterpillar

Illustration 1 g01283665
(1) Flange (input shaft)
(2) Housing
(3) Turbine
(4) Stator
(5) Impeller
(6) One-way clutch
(7) Output shaft
(8) Hub
(9) Lockup Clutch The torque converter is driven by the engine flywheel.The torque converter consists of the following components:
Impeller (5)
Turbine (3)
Lockup clutch (9)
Stator (4)
One-way clutch (6) (stator)The lockup clutch permits the machine to operate in direct drive in order to keep the power loss at a minimum. The one-way clutch holds the stator when the torque converter drive is used. The one-way clutch allows the stator to turn freely when direct drive is used.The torque converter case is fastened to the flywheel case for the engine. Output shaft (7) connects the torque converter to the transmission planetary group.The engine flywheel turns flange (1), rotating housing (2) and impeller (5). The impeller directs oil onto the blades of turbine (3). This action causes the turbine to turn. The turbine directs the oil onto stator (4).
Illustration 2 g01005408
(10) Race
(11) Cam
(12) Spring
(13) Slot
(14) Cam Surface
(15) Roller Stator (4) is connected to cam (11) by the spline. When the hydraulic oil tries to move the stator in the opposite direction to the turbine, rollers (15) are forced into the narrow end of slot (13). This action prevents the cam and stator assembly from rotating around the carrier. Since the cam is held stationary, the stator cannot turn and the one-way clutch is locked up. The stator now directs most of the oil back to the impeller. The remainder of the oil goes out of the torque converter. The oil, that goes back to the impeller from the stator, moves in the same direction as the rotation of the impeller. Since this oil is moving in the same direction as the impeller, the torque output from the torque converter is multiplied.The output torque requirement can be less than or equal to the input torque. This situation can occur when ground speed is high and the resistance is low. Then, the turbine will be turning quickly. The oil that flows through the turbine strikes the back of the stator blades. This action causes the stator to start turning in the same direction as the turbine. Cam (11) then rotates so that rollers (15) occupy the wide end of opening (13). Stator (4) is then free to rotate around the carrier. The oil then flows through the turbine and out of the converter.Turbine (3) turns hub (8). The hub turns output shaft (7). Power is sent through the output shaft to the transmission planetary group.Lockup clutch (9) is part of the torque converter. The lockup clutch is located between the engine flywheel and the turbine. The lockup clutch is engaged under the following conditions:
sufficient input speed to the transmission
sufficient transmission oil pressureWhen the lockup clutch is engaged, the impeller and the turbine turn at the same speed as the engine. Also, there is no loss of power in the torque converter. The connection between the engine and the transmission is now direct.Torque converter drive is available in first gear, second gear, and reverse