HOSE AS 8W0302 - Caterpillar

Caterpillar Products: AllIntroduction
European Union Compliant CE MarkedA non-exhaustive list of operations that may cause product damage are identified by "" labels on the product and in this publication.Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The warnings in this publication and on the product are, therefore, not all inclusive. If a tool, procedure, work method, or operating technique that is not recommended by Caterpillar is used, the operator must be sure that the procedures are safe. The operator must also be sure that the product will not be damaged or made unsafe by any unspecified procedures.The information, specifications, and illustrations in this publication are based on information that was available at the time that the publication was written. The specifications, torques, pressures, measurements, adjustments, illustrations, and other items can change at any time. These changes can affect the service that is given to the product. Obtain the complete and most current information before you start any job.When replacement parts are required for this product Caterpillar recommends using Caterpillar replacement parts or parts with equivalent specifications including, but not limited to, physical dimensions, type, strength, and material.Important Safety Information
Illustration 1 g02139237
Think SafetyMost accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools to perform these functions properly.Improper operation, lubrication, maintenance, or repair of this product can be dangerous and could result in injury or death.Do not operate or perform any lubrication, maintenance, or repair on this product until you have read and understood the Tool Operating Manual.Safety precautions and warnings are provided in this manual and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons.The hazards are identified by the "Safety Alert Symbol" and followed by a "Signal Word" such as "DANGER","", or "CAUTION". The Safety Alert "" label is shown below.General Information Section
Introduction
Illustration 2 g02337460
(A) Small Orifice (B) Large Orifice (C) Tubing (D) 368-8645 Tool Kit (CRANKCASE PRESSURE) (E) Carrying CaseThe 368-8645 Tool Kit (CRANKCASE PRESSURE) measures gauge and differential pressure in the range of 0.13800 bar (2.0 psi). The meter has 11 units of measure and a differential input that has quick disconnect fittings.Advanced features include DATA HOLD, MIN-MAX-AVG RECORD mode, ZERO/OFFSET, AUTO POWER OFF, and USB PC interface.The instrument is shipped tested and calibrated.Additional Contact Information
For additional product support questions concerning this tool, contact the Caterpillar Dealer Service Tools Hotline at:
USA: 1-800-542-8665, Option 1International: 1-309-578-7372E-mail: dealerservicetool_hotline
Nomenclature
Specifications
General Specifications
Table 1
General Specifications    
Display     Four-digit LCD with function indicators    
Units of Measure     BAR, mBAR, kg/cm?, mm Hg, inches Hg, kPa, feet H2O, inches H2O, cm H2O oz in?    
Accuracy     0.3%FS (@25°C)    
Repeatability     0.2% to 0.5% FS    
Linearity/Hysteresis     0.3%FS