HOSE AS 8X5967 - Caterpillar

Illustration 2 g03736651
Remove four bolts (4) and the four washers. Reposition cable assembly (2) and bracket assembly (5).
Disconnect three hose assemblies (3) from the piston pump.
Illustration 3 g03736652
Loosen the clamp and remove hose (6).
Disconnect hydraulic fitting (7).
Disconnect two hose assemblies (8) from the bottom of the piston pump.
Illustration 4 g03736653
Disconnect two hose assemblies (9) from the piston pump.
Disconnect two hose assemblies (10) from the piston pump.
Illustration 5 g03736654
Remove the cable straps securing harness assembly (11) to the pump drive plate.
Illustration 6 g03736655
Remove the cable straps securing harness assembly (11) to the engine.
Remove the bolt and cable assembly (12) from the engine.
Remove the nut, the washer, and cable assemblies (13) from the electric starting motor.
Remove the nut, the washer, and wire assembly (14) from the electric starting motor.
Illustration 7 g03736657
Disconnect wire assembly (15) from the alternator.
Remove the nut and cable assembly (16).
Remove cable strap (17) and reposition harness assembly (11).
Illustration 8 g03736658
Remove bolt (18), the two washers, and the nut. Reposition mounting bracket (19) out of the way.
Illustration 9 g03736659
Disconnect connector (20) and connector (21).
Remove cable strap (22).
Disconnect fuel hose assembly (23).
Illustration 10 g03736660
Remove bolt (24), the ladder clip, and the spacer.
Remove cable straps (25). Reposition the hoses and the harness assembly.
Illustration 11 g03736661
Disconnect fuel hose assembly (26).
Reposition fuel hoses (23) and (26) out of the way.
Illustration 12 g03736662
Attach a suitable lifting device and Tooling (A) to engine (27). The weight of engine (27) and the piston pump is approximately 567 kg (1250 lb).
Remove two bolts (28), the two washers, and the flexible mounts, and two nuts.
Remove two bolts (29), the two washers, and the flexible mounts, and two nuts.
Remove engine (27) and the piston pump. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 6V-6146 Load Leveler Gp 1
Install engine (27) in the reverse order of removal.
Apply rubber lubricant to flexible engine mounts prior to installation.
Tighten the nut that secures cable assembly (16) to the alternator to a torque of 7.75 0.25 N m (70 2 lb in).
Tighten the nut to wire assembly (14) to a torque of 5.8 1 N m (51 9 lb in).
Tighten the nut to cable assemblies (13) to a torque of 15 3 N m (133 27 lb in). End By:
Install the radiator, hydraulic oil cooler, and fuel cooler. Refer to Disassembly and Assembly, "Radiator, Hydraulic Oil Cooler, and Fuel Cooler - Remove and Install".
Install the gear pump (steering and vibratory). Refer to Disassembly and Assembly, "Gear Pump (Steering and Vibratory) - Remove and Install".
Install the hydraulic tank. Refer to Disassembly and Assembly, "Hydraulic Tank - Remove and Install".