9D5988 HOSE ASSEM. Caterpillar parts
120G, 12G, 130G, D7G
Rating:
Alternative (cross code) number:
CA9D5988
9D-5988
9D5988
CA9D5988
9D-5988
9D5988
MOTOR GRADER, TRACK-TYPE TRACTOR,
Number on catalog scheme:
28
For full view, you need register
Information:
Illustration 26 g01192123
ApplyTooling (K) to the upper bores.Note: Proper alignment of the bores is important.
Install pin assembly (19). Install bolt (18) and the washer.
Illustration 27 g01193050
ApplyTooling (K) to the lower bores.
Install pin (16) .
Connect the steering frame lock.
Illustration 28 g01192098
Note: Proper alignment of the bores will ensure that spacer (17) will seat properly.
Install lower spacer (17) in the lower hitch. Make sure that the spacer is installed in the original position.
Illustration 29 g01193052
Install lower hitch mount plate (14). Install two bolts (13). The torque for bolts (13) is 68 N m (50 lb ft).
Use a thickness feeler gauge in order to measure the distance between the frame and the lower hitch mount plate. Check completely around the lower hitch mount plate. Record the minimum measurement that is found.
Illustration 30 g01192772
Remove lower hitch mount plate (14) .
Install shims (15) under lower hitch mount plate (14). The shims thickness should equal the measurement from Step 54 minus 0.25 mm (0.010 inch).
Illustration 31 g01192067
Install bolts (12) and (13). The torque for bolts (12) is 100 20 N m (75 15 lb ft). The torque for bolts (13) is 570 80 N m (420 59 lb ft).
Illustration 32 g01192014
Remove the suitable lifting device and Tooling (B) from the loader frame.
Illustration 33 g01192031
Install bolt (11). Repeat on the other side of the loader frame.
Illustration 34 g03313458
Install light assemblies (9) and sensor (10) .
Illustration 35 g01192002
Remove the suitable cribbing from the front of the rear frame.
Illustration 36 g00432878
Remove Tooling (A) from the rear frame.
Illustration 37 g01193054
Install pin assembly (7) and bolt (6) to the rod end of both steering cylinders.
Illustration 38 g01191942
Connect hose assembly (3) .
Install bolt (4), the washer, and the clip.
Connect harness assembly (5) .
Illustration 39 g00847099
Connect hose assembly (2) to fixed axle (1) .
Fill the oil from the hydraulic tank. Refer to Operation and Maintenance Manual for the correct procedure.End By:
Install the steering frame lock.
Install the center drive shaft.
Install the cab.