HOSE ASSEM. 9J9545 - Caterpillar

Inspect the Linkage
Illustration 1 g03003577
(1) Lift Arm (2) Bucket (3) Inspection Points for the Bucket Hinge.Periodically inspect the bucket linkage. The gap between the bucket and the linkage should not exceed the thinnest shim that is available for the bucket assembly.
Lower the lift arm assembly (1) to suitable blocking. Rest the bucket (2) on the ground.
Use a gauge to measure the gap at the hinge.
If the measurement exceeds the required amount, new shims must be installed.Installing Shims for the Hinge on the Bucket
Note: Refer to the Disassembly and Assembly Manual, "Bucket - Remove" for the correct procedure for removing the pins in the linkage.
Illustration 2 g01345720
(2) Bucket (4) Install washers on lift arm.Install washers and pin assembly to the bucket. When possible, use washers on both sides of the lift arm to reduce the gap between the lift arm and the hinges on the bucket.Note: Refer to the Disassembly and Assembly Manual, "Bucket - Install" for the correct procedure for installing the pins in the linkage.