HOSE 9R1652 - Caterpillar

Illustration 1 g02557898
Schematic of the action alarm
This diagnostic code is associated with the action alarm. The FMI 06 means that the Advisor module has determined that the current of the alarm circuit is above normal or grounded to the circuit.The possible causes of this diagnostic code are listed below:
The energize circuit of the alarm is shorted to ground.
The alarm has failed.
The display module has failed. A display module failure is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0271 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE ALARM
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the alarm with the active diagnostic code from the machine harness for the display module. Expected Result:The CID 0271 FMI 06 diagnostic code changes to a CID 0271 FMI 05 diagnostic code when the alarm is disconnected.Results:
YES - The CID 0271 FMI 06 diagnostic code changes to a CID 0271 FMI 05 diagnostic code when the alarm is disconnected. The circuit is correct.Repair: The alarm has failed. Repeat this test "CHECK THE ALARM" in order to verify the failure of the alarm. Replace the alarm.STOP
NO - The CID 0271 FMI 06 diagnostic code remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE ALARM FOR A SHORT TO GROUND
Turn the key start switch and the disconnect switch to the OFF position.
Verify that the alarm remains disconnected from the machine harness.
Disconnect the machine harness connectors from the display module.
At the machine harness connector for the display module, measure the resistance from the signal contact IC-23 (wire 410-WH(White)) to all contacts that are used in the machine harness connectors for the display module. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between IC-23 (wire 410-WH(White)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK HARNESS CONNECTORS
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0271 FMI 06 diagnostic code. Expected Result:The CID 0271 FMI 06 diagnostic code is active.Results:
YES - The CID 0271 FMI 06 diagnostic code is active. The diagnostic code has not been corrected. The display module may have failed.Repair: A display module failure is unlikely. Exit this procedure and perform this procedure again. If the cause of the diagnostic code