HOSE A 9W0061 - Caterpillar

1. Remove cover (1) from the front of the cylinder block. 2. Remove plunger assembly (2) and spring (3) from the front of the cylinder block. 3. Remove the gear assembly, idler gear and shaft from over cover (4) on the rear of the cylinder block.4. Remove cover (4) from the rear of the cylinder block. 5. Remove plunger assembly (5) and spring (6) from the rear of the cylinder block. The following steps are for installation of the oil sequence valves.6. Put clean engine oil on spring (6) and plunger assembly (5), and install them as shown in the rear of the cylinder block.7. Install cover (4). Install the idler gear, shaft and gear assembly over cover (4) on the rear of the cylinder block.8. Put clean engine oil on spring (3) and plunger assembly (2), and install them in the front of the cylinder block as shown.9. Install cover (1) to hold the plunger assembly and spring in position.End By:a. install flywheel housingb. install front drive housing