HOSE AS 9W2887 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Illustration 1 g02294897
Attempts to program the Electronic Control Module (ECM) result in an error message. Refer to Illustration 1.Solution
Illustration 2 g02296035
Part number stamping (1) Part number (2) Suffix codeRemanufactured 10R-4332 Electronic Control Modules that have a suffix code of "DH" should have a test flash performed prior to installation on a machine. If the test flash results in the error message shown above, then the ECM software file and the ECM are not compatible. Refer to Illustration 1. The ECM should be replaced with another 10R-4332 Electronic Control Module that has a "DK" suffix code.Note: Electronic Control Modules with a "DK" suffix code have only been in production since 5July 2010 effective with serial number 1870L001DK. File a standard warranty claim for this issue. Claim .5 part hours and note the ECM component serial number, including the suffix code.