HOUSING GP-FLYWHEEL 1044775 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install a new O-ring seal for the joint between the auxiliary water pump and the front housing. Apply a light coat of glycerin to the O-ring seal prior to installation.
Attach Tooling (A) and a suitable lifting device to water pump (3). The weight of water pump (3) is approximately 68 kg (150 lb).
Install a new O-ring seal for the joint between the water pump and the front housing. Apply a light coat of glycerin to the O-ring seal prior to installation.
Illustration 1 g03082116
Install Tooling (B) in the front housing.
Place the auxiliary water pump (4) on the front housing and slide the auxiliary water pump (4) into position.
Install six bolts (3). Tighten bolts to a torque of 60 12 N m (44 9 lb ft). Remove Tooling (B) and install remaining bolts (3).
Illustration 2 g03082360
Install three bolts (2) and bolt (1). Tighten bolts (2) and (1) to a torque of 47 9 N m (35 7 lb ft).
Connect the connection for the water inlet.
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".