HOUSING AS 1123632 - Caterpillar

Illustration 109 g02166993
Signal Generator Output Basic Steps
Use the LEFT and RIGHT Direction keys to adjust the frequency resolution in increments of 1, 10, 100, and 1000 Hz
Use the Amplitude function key to adjust the signal output amplitude between two ranges of voltage ( 4 or 0-8). Press the function key and then press the "ENTER" key to select the amplitude.
Use the On / Off function key to start and stop the signal output.
Use the UP and DOWN Direction keys to select the desired output frequency.Calibrator Output
Illustration 110 g02160962
DIM Audio Jack Location
Illustration 111 g02167236
Calibrator Output Basic StepsConnect the 8T-5197 Cable As to the audio jack on the back of the Multi-Tool DIM
Use the LEFT and RIGHT Direction keys to adjust the frequency resolution in increments of 1, 10, 100, and 1000 Hz
Use the On / Off function key (F1) to start and stop the signal output.
Use the UP and DOWN Direction keys to select the desired output frequency.SERVICE PARTS
Use the CAT Media Logistics System to order Software License Cards and use the CAT Parts Distributions System to order all other parts.
Illustration 112 g02166896
Table 68
Item     Part No     Description    
1     285-0908     Multi-Tool    
2     285-0905     Internal Battery Power Pack    
3     285-0907     Diagnostic Interface Module (DIM)    
4     285-0896     5 Pin DIN Adapter    
5     285-0906     Universal AC/DC Power Supply with
Four International Power Cords    
6     285-0904     Battery DC Power Cable Assembly    
7     285-0903     Blowby Cable Assembly with Ground Clip    
8     285-0902     Carrying Case
(tools in photo not included)    
9     308-7269     Carrying Case
67 x 40 x 43 cm (26 x 16 x 17 inch)    
10     NETG5044     Blowby/Airflow Indicator
Software License Card    
11     NETG5045     Signal Generator
Software License Card    
12     NETG5046     Electronic Position Indicator
Software License Card    
13     NETG5047     Engine Timing Indicator
Software License Card    
14     NETG5049     Multi Tach 2
Software License Card    
15     NETG5051     Digital Thermometer
Software License Card    
16     NETG5053     Fuel Flow Monitor
Software License Card    MANUFACTURER-S LIMITED WARRANTY
THIS WARRANTY IS EXPRESSLY LIMITED TO ORIGINAL RETAIL BUYERS OF THE MANUFACTURER-S ELECTRONIC DIAGNOSTIC TOOL ("UNITS")The Manufacturer-s Units are warranted against defects in materials and workmanship for 3 years (36 months) from date of delivery. Cables are warranted against defects in materials and workmanship for 90 days (3 months) from date of delivery. This warranty does not cover any Unit that has been abused, altered, used for a purpose other than that for which it was intended, or used in a manner in consistent with instructions regarding use. The sole and exclusive remedy for any Unit found to be defective repair or replacement, at the option of the manufacturer. In no event shall the Manufacturer be liable for any direct, indirect, special, incidental, or consequential damages (including lost profit) whether based on warranty, contract, tort, or any other