HOUSING-CLUTCH 1131832 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     8S-7640     Stand     1    
8S-7621 Tube     1    
8S-7615 Pin     1    
B     6V-0113     Cylinder Group     1    
9U-6809 Fast Runner Nut Assembly     1    
FT-1395 Plate     1    
9U-6811 Puller Stud     1    
141-1785 Sleeve     1    
3S-6224 Electric Hydraulic Pump     1    Start By:
Remove the stick. Refer to Disassembly and Assembly, "Stick - Remove" in this manual.
Remove the fuel tank. Refer to Disassembly and Assembly, "Fuel Tank - Remove" in this manual.Note: It is not necessary to remove the fuel tank if Tooling (B ) is not needed to remove the boom pin.
Retract the stick cylinder. Tie the stick cylinder in order to prevent extension.
Lower the boom onto Tooling (A) .
Illustration 1 g01173151
Attach a suitable lifting device in order to support cylinder (1) .
Disconnect grease hose assembly (2) .
Remove bolts (3). Remove plate (4) and the washer.
Push pin (5) inward. Cylinder (1) will release from the boom. Lower boom cylinder (1) onto a suitable support.
Repeat Steps 3 through 6 for the opposite side.
Install a suitable lifting device onto pin (5). Lower boom cylinder (1) .
Illustration 2 g01173276
Disconnect hose assemblies (6) .
Illustration 3 g01173280
Disconnect clamp (7) and harness assembly (8) .
Illustration 4 g01173291
Install plate (4) and bolts (3) onto pin (5). Attach a suitable lifting device onto pin (5) and pin (9) .
Illustration 5 g01173324
Illustration 6 g01173330
Remove bolt (11). Install Tooling (B) in order to remove pin assembly (10). The weight of Tooling (B) and pin assembly (10) is approximately 240 kg (530 lb). The weight of pin assembly (10) is approximately 82 kg (180 lb).
Illustration 7 g01173336
Remove boom (12). The weight of boom (12) is approximately 2359 kg (5200 lb).