HOUSING GP-FLYWHEEL 1166718 - Caterpillar

PARTS NEEDED
No parts needed for this program
ACTION REQUIRED
Perform this Rework Procedure with another rework, service program, or periodical maintenance.
Rework the platform harness by exchanging the pin assignment at the connector. Refer to the attached Rework Procedure.
Before completing the attached Rework Procedure, please review the safety actions in the Operation and Maintenance Manual for your machine.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-3000 hrs,
0-36 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
1. Park the machine in a safe, hard flat area, lower all the attachments to the ground, shut off the engine and, wear all the required Personal Protection Equipment.
2. Disconnect the battery before starting this Rework Procedure.
3. Remove the side cover located on the right side of the cab. Refer to Image1.3.1.
Image1.3.1
4. Remove the circuit breaker mount bracket. Refer to Image1.4.1.
Image1.4.1
5. Disconnect the platform harness and roof harness. Refer to Image1.5.1 and 1.5.2.
Image1.5.1
Image1.5.2
6. Exchange pin assignment number 2 and number 10 on the platform harness connector.
Note: Pin assign is different between 901C2 and 902C2-903C2 machines, but the exchanged pins are same.
- Wiring 120 C24 Yellow should be re-assigned from Pin 2 to Pin 10.
- Wiring 122 C27 Blue should be re-assigned from Pin 10 to Pin 2.
Refer to Image1.6.1. for 901C2 machines and 1.6.2 for 902C2-903C2 machines.
Image1.6.1
Image1.6.2
7. Re-install the connector.
8. Re-install the bracket that was removed.
9. Re-install the side cover.