1232144 HOUSING Caterpillar parts
311B, 312B, 312B L, 313B, 315B, 315B L, 317B LN, 318B
Rating:
Alternative (cross code) number:
CA1232144
123-2144
1232144
CA1232144
123-2144
1232144
Weight: 33 pounds 15 kg.
EXCAVATOR,
Compatible equipment models: 1232144:
Number on catalog scheme:
22
For full view, you need register
Information:
Illustration 1 g02041453
Schematic of the rear track position sensorThis diagnostic code is associated with the rear track position sensor. The FMI F13 means that the ECM has determined that the sensor signal is not properly calibrated. The possible causes of this failure are listed below:
The sensor may not be calibrated properly.
The ECM has been flashed with new software.
The sensor has failed.
The ECM has failed (unlikely).Note: The following test procedure may create other diagnostic codes. Clear these diagnostic codes when the original diagnostic code has been corrected. Also, ensure that the CID 744 FMI F03 or FMI F04 are not active. Ensure that the diagnostic code of CID 744 FMI F13 is active before performing this procedure.System Response:The machine response is listed below:
A Category 2 warning is shown on the Computerized Monitoring System (CMS) for the sensor.
A fault on the rear track position sensor will prevent the steering from moving to the full right or full left positions.
A fault on the rear track position sensor will only allow steering in the REAR position.Test Step 1. CHECK THE CALIBRATION OF THE SENSOR
Perform the necessary adjustment and calibration procedures for rear track position sensor. Refer to the Testing and Adjusting, "Rear Steering Sensor - Calibrate" section of the service manual for these procedures. Always do the sensor calibration under the following conditions:
FULL RIGHT (c13)
CENTER/STRAIGHT (c14)
FULL LEFT (c15)
Observe the status of the CID 744 FMI F13.Results:
OK - The CID 744 FMI F13 is not active. The calibration corrected the condition that caused the CID 744 FMI F13. Resume normal operation.STOP
NOT OK - The CID 744 FMI F13 is still active.Repair: The diagnostic code is still active. Verify that the correct software has been flashed into the ECM or that the correct ECM is installed on the machine. Then repeat the calibration. If the diagnostic code is still active and the cause of the diagnostic code is not found, replace the ECM. It is unlikely that the ECM has failed. Verify that the sensor and associated circuits are correct before you replace the ECM.STOP
Caterpillar parts catalog:
Parts housing Caterpillar catalog:
1211038
HOUSING-RECEPTACLE
307B, 307C, 308C, 311B, 311C, 312B, 312B L, 314C, 315B, 315B FM L, 315B L, 318B, 320B, 320C, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 322B L, 322C, 323...
307B, 307C, 308C, 311B, 311C, 312B, 312B L, 314C, 315B, 315B FM L, 315B L, 318B, 320B, 320C, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 322B L, 322C, 323...
1909813
HOUSING
M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C
M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C
1384272
HOUSING
320C, 320D FM, 543, 621F, 621G, 627F, 627G, 631E, 631G, 637E, 637G, 914G, HF181, HF201, HF201B, HF202, HF221, HF222, IT14G, IT14G2, M312, M313C, M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C,...
320C, 320D FM, 543, 621F, 621G, 627F, 627G, 631E, 631G, 637E, 637G, 914G, HF181, HF201, HF201B, HF202, HF221, HF222, IT14G, IT14G2, M312, M313C, M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C,...
1487329
HOUSING
M312, M315, M318, M320
M312, M315, M318, M320
1489037
HOUSING
M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318, M318C, M318C MH, M318D, M318D MH, M320, M322C, M322D, M322D MH
M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318, M318C, M318C MH, M318D, M318D MH, M320, M322C, M322D, M322D MH
1489036
HOUSING
M312, M313C, M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C, M325C MH, M325D L MH, M325D MH
M312, M313C, M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C, M325C MH, M325D L MH, M325D MH
1388273
HOUSING-LOCK
312B L, 315B L, 317B LN, 318B, 320B, 322B LN, 325B L, 330B L, 345B II, 345B L, 365B, 365B II, 385B, 5090B
312B L, 315B L, 317B LN, 318B, 320B, 322B LN, 325B L, 330B L, 345B II, 345B L, 365B, 365B II, 385B, 5090B
1388274
HOUSING-LOCK
312B L, 315B L, 317B LN, 318B, 320B, 322B LN, 325B L, 330B L, 345B II, 345B L, 365B, 365B II, 385B, 5090B
312B L, 315B L, 317B LN, 318B, 320B, 322B LN, 325B L, 330B L, 345B II, 345B L, 365B, 365B II, 385B, 5090B
1318440
HOUSING AS
312B L, 315B L, 317B LN, 318B, 320B, 322 FM L, 322B L, 322B LN, 325B L, 325D FM LL, 330, 330B L, 330D FM, 345B, 345B II, 345B II MH, 345B L, 350, 365B, 365B II, 375 L, 385B, 5080, 5090B, 5110B, 568 FM...
312B L, 315B L, 317B LN, 318B, 320B, 322 FM L, 322B L, 322B LN, 325B L, 325D FM LL, 330, 330B L, 330D FM, 345B, 345B II, 345B II MH, 345B L, 350, 365B, 365B II, 375 L, 385B, 5080, 5090B, 5110B, 568 FM...
1690324
HOUSING AS-COUPLER
312B L, 312C, 312D, 312E, CW-10
312B L, 312C, 312D, 312E, CW-10
311B, 311C, 311D LRR, 311F LRR, 312B, 312B L, 312C, 312C L, 312D, 312D L, 312D2, 312E, 312E L, 313B, 313D, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C
1886398
HOUSING-MOTOR
312B L, 312C
312B L, 312C