HOUSING AS 1542692 - Caterpillar

Failure to properly service the batteries may cause personal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow the jump start cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts the skin or eyes.Always wear eye protection when starting a machine with jump start cables.Improper jump start procedures can cause an explosion resulting in personal injury.When using jumper cables, always connect the positive (+) jumper cable to the positive (+) battery terminal first. Next, connect the negative (-) jumper cable to the frame away from the batteries. Follow the procedure in the Operation and Maintenance Manual.Jump start only with an energy source of the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the energy source is connected.
Do not attempt to charge a battery that has ice in any of the cells.Charging a battery in this condition can cause an explosion that may result in personal injury or death.Always let the ice melt before attempting to charge.
When starting from another machine, make sure that the machines do not touch. This can prevent damage to engine bearings and electrical circuits.Turn on (close) the battery disconnect switch prior to the boost connection to prevent damage to electrical components on the stalled machine.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.This machine has a 24 volt starting system. Use only the same voltage for jump starting. Use of a higher voltage damages the electrical system.
Use of Jump Start Cables
Place the transmission control on the stalled machine in the NEUTRAL position. Engage the parking brake. Lower all attachments to the ground. Move all controls to the HOLD position.
On the stalled machine, turn the engine start switch to the OFF position. Turn off the accessories.
On the stalled machine, turn the battery disconnect switch to the ON position.
Move the machine or the auxiliary power source close to the stalled machine so that the cables can reach. DO NOT ALLOW THE MACHINE OR THE AUXILIARY POWER SOURCE TO CONTACT THE STALLED MACHINE.
Stop the engine on the machine that is the electrical source. (If you are using an auxiliary power source, turn off the charging system.)
Illustration 1 g03874519
The batteries are located on the left side of the machine. Remove the bolts that secure the access panel for the batteries. Remove the access panel.
Check the battery caps for correct placement and for correct tightness. Make these checks on both machines. Make sure that the batteries in the stalled machine are not frozen. Check the batteries for low electrolyte.
Route the jump-start cables around the steps and away from the mounting and dismounting paths. Connect the positive jump-start cable to the positive cable terminal of the discharged battery. Do