HOUSING GP-AXLE 1808634 - Caterpillar

11. Remove sleeve (15) from carrier (14) with tooling (D). 12. Turn the impeller wheel over. Remove eight bolts (16) and two plates (17). Remove the gear assembly from the wheel assembly. 13. Remove the bearing from the gear assembly with tooling (E) and an arbor press.14. Put the rotating housing on wood blocks as shown. 15. Remove bolts (18) and retainer (19). 16. Remove bolt (20) and retainer (21) from the end of the shaft. 17. Remove ring (22) from the shaft with tool (B). 18. Remove ring (23) with tool (B). 19. Remove the shaft and turbine as a unit from the housing. Hit the end of the shaft with a soft faced hammer to remove the unit from the housing. 20. Put the turbine and shaft in position in an arbor press as shown. Remove the shaft and bearing from the turbine with tooling (C) and the press. 21. Remove ring (26) and adapter (24) from the gear in the converter housing.22. Remove ring (27) and adapter (25) from the gear. 23. Turn the converter housing on its side. Remove two bolts (28) and two gears (29) from the housing. 24. Remove rings (30) from two gears (29). Remove the bearings and retainers from each gear as a unit. 25. Remove the retainers from each bearing with an arbor press. 26. Remove tube assembly (32). Remove strainer assembly (33).27. Remove lip type seal (31) from the converter housing. Assemble Torque Converter
Before the torque converter is assembled, see Torque Converter Clearance Checks. These clearances must be correct for the torque converter to operate with efficiency.
1. Install the ring in the groove that is in the converter housing which is under the lip type seal. Install the lip type seal in the converter housing with tooling (A). Install the seal until it is even with the outside surface of the housing and with the lip of the seal toward the inside of the housing. 2. Make sure strainer assembly (1) is clean and free of dirt and foreign material.3. Install strainer assembly (1). 4. Install tube assembly (2). 5. Heat two bearings (3) to a maximum temperature of 275°F (135°C). Put the bearings in position over the two retainers (4) as shown. 6. Install the bearings and retainers in two gears (5). Make sure the threaded hole in the retainer is toward the bottom of gears when they are installed. 7. Put two gears (5) in position in the converter housing as shown. Install bolts (6) that hold them. Tighten the bolts to a torque of 36 2 lb.ft. (46 3 N m). 8. Install adapters (7) in both gears. Install rings (8) that hold the adapters in position. 9. Put shaft (10) in a vise as shown. Do not damage the splines on the shaft.10. Install ring (9) with tool (D). 11. Heat inner race (11) to a temperature of 275°F (135°C). Install the race on the shaft as shown until it makes contact