HOUSING AS 1957876 - Caterpillar

Illustration 1 g01261545
(1) "Swap Sign" softkey
If required, use any of the following tools to set the vertical offset value:
Edit the "A" Vertical offset field directly.
Press "Swap Sign" in order to change the sign of the offset.
Press "Set 0.00" in order to set the offset to zero.
Press "+0.015" or "–0.015" in order to increment or decrement the offset by 15 mm (0.6 inch).
If required, and if the field is available, use one or more of the following tools to set the working surface lift value:
Press the "Next" key in order to highlight the field and edit the "Working Surface B) Perpendicular Lift" field directly.
Press "Swap Sign" in order to change the sign of the offset.
Press "Set 0.00" in order to set the offset to zero.
Press "+0.100" or "–0.100" in order to increment or decrement the offset by 100 mm (4 inch).Note: Remember, if you are using a layered lift working surface, then the working surface offset you are allowed to select depends on the side slope cut/fill setting in the "Select Design File" dialog. For example, if the "Side Slope" soft key is set to Fill, then the layered lift offset must be negative.
Press "OK" in order to confirm the settings, or press "ESC" in order to exit without saving. You are returned to a guidance screen.