HOUSING 1G8303 - Caterpillar

1G8303 HOUSING Caterpillar parts PM-565

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1G8303
1G-8303
1G8303

Weight: 55 pounds 25 kg.

Buy HOUSING 1G8303 Caterpillar genuine, new aftermarket tractor parts with delivery
COLD PLANER,

Compatible equipment models: 1G8303:

COLD PLANER PM-565 Caterpillar

Number on catalog scheme: 44

For full view, you need register

Information:

Table 19
Contents of the 454-7537 Display Mounting Gp
Quantity Part Number Description
4 1D-4533 Bolts
1 3E-4352 Hard Washer
6 3S-2093 Cable Straps
1 3T-0852 Locknut
4 6V-5215 Bolts
4 8T-4121 Hard Washers
7 8T-4171 Bolts
4 8T-9364 Bolts
15 9X-8256 Washers
1 111-1323 Contact Block
1 125-9946 Rotary Switch
1 132-1829 Alarm Gp
1 415-6921 Wiring Harness
1 415-6983 Display Module Gp
1 415-7016 Wiring Harness
2 436-0336 Protectors
1 454-7538 Cover
1 454-7539 Bracket As
1 454-7540 Bracket As
8 8C-5607 Isolation Mount
4 8C-5608 Spacers Refer to Table 19 for the contents of the 454-7537 Display Mounting Gp.
Illustration 28 g03731502
Disassembled 3-D dual display view
Note: The procedure for mounting the dual display assumes that a dual display and supporting bracket is already present on the drill. Before starting this procedure, remove the top display and bracket from the bottom display. Keep the bottom display and supporting bracket intact. Refer to Illustration 28.Perform the following procedure to install the dual display monitor:
Install the 454-7539 Bracket As on the 454-7540 Bracket As by using the four 6V-5215 Bolts and four 8T-4121 Hard Washers. Tighten the bolts to 28 7 N m (247.82 61.96 lb in).
Place the USB, Switch, and Alarm Buzzer on the indicated places on the 454-7540 Bracket As. Tighten the buzzer nut to 28 7 N m (247.82 61.96 lb in).
Place the upper display G610 into the 454-7540 Bracket As to create the upper assembly. Tighten the bolts to 12 3 N m (8.85 2.21 lb ft).
Remove the existing mounting bolts from the bottom display bracket.
Illustration 29 g03731534
Place the upper assembly that was created in Step 3 onto the existing bottom assembly (display and bracket). Refer to Illustration 29.
Fasten these two brackets assemblies (upper and lower) together with the four 1D-4533 Bolts. Tighten to 12 3 N m (8.85 2.21 lb ft).
Replace the existing shock mounts with the new 8C-5607 Isolation Mounts and the new 8C-5608 Spacers provided with the upgrade kit.
Route the harness to the upper display (G610).
Illustration 30 g03731315
Typical dual display arrangement
Install the back cover using the seven 8T-4171 Bolts provided in the upgrade kit. Refer to Illustration 30.