HOUSING-PUMP 2243253 - Caterpillar

Illustration 3 g03682091Set a Target Compaction Value
Illustration 4 g03886702
(6) Interactive Scroll Bar
Illustration 5 g03886710
(8) Compaction Target Value
(9) Intelligent Compaction Slider Bar
(10) Target Value Box with TARGET button
(11) Compaction page with Keypad
(12) OK buttonAfter the operator determines a Compaction Target Value, the numbers are entered on a keypad on the "Compaction" page (11). The Compaction Target Value (8) and an "Intelligent Compaction Slider Bar" (9) will appear on the Compaction page.
Scroll to the Compaction page by pressing the DOWN Arrow button of the scroll bar that is located on the right side of the Display. The Compaction settings page will appear.
On the Compaction page, press the "Target" button located in the Target Value box (10). A Compaction page will appear with a keypad (11).
Press the keypad numbers to enter a "Target Compaction Value".
Press "OK" to set the number. The "Actual Compaction Value" will appear with the Intelligent Compaction Slider Bar (9).
Press the OK button (12) to set that number. The “Actual Compaction Value” will appear with the “Intelligent Compaction Slider Bar”.Note: The Intelligent Compaction Slider Bar shows the Actual Compaction Value compared to the Target Value Range.Intelligent Compaction Slider Bar
The Compaction page will show a two-colored Intelligent Compaction Bar with a slider (see Illustration 6). The bar represents the Target Compaction Value as a range of the operator-entered Targeted Compaction Value. The slider allows the operator to see (in real time) the Actual Compaction Value compared to the Target Value range.
Illustration 6 g03893860For example, if the target is 85:
A: The lower limit is 17 (20% of target).
B: The Actual Compaction Value is 76.
C: The break between gray and green on the bar is 76.5 (90% of target).
D: The upper limit is 110.5 (130% of target).The Actual Value is displayed as the slider bar moves along the bar and as the Actual Compaction Value changes. The Actual value will be normalized based on the Target Value. This is done so that the Display’s bar will always have the same range and will not change its limits. The slider bar (width) will have range of +/- 5 of the Actual Compaction Value.Intelligent Compaction: Failure Mode Functionality
Illustration 7 g03682188The Machine Drive Power (MDP) algorithm requires an acceptable working level of certain machine parameters to convey an accurate MDP value. Examples of unacceptable conditions would include:
The blade is not engaging the material.
The machine is not turning.
The machine has not stopped.
The machine is not on a grade greater than 6 degrees.
The machine is not in third gear.
The machine throttle is not less than 90%.If any of the inputs to the MDP fail, the MDP will display "***" (three asterisks).Work Monitor
Illustration 8 g03887699
(6) Interactive Scroll BarThe Work Monitor Page provides useful machine information such as fuel level and consumption. Production, Cycles, and Average Fuel Rate also appear on Models 988, 990, and 994.To access the Work Monitor, press the UP or DOWN arrow button on either end of the Interactive Scroll Bar (6).Left Side Buttons
Payload
Illustration 9 g03887711
To access the Payload Page, press the Payload Button (7) on the Main Performance Page.
(7) Payload