HOUSING-REGULATOR 2355046 - Caterpillar

Table 1
VIMS Service Operations
Service Operation Service Program
Code Service Program
Code Number
Display Language - Set LA (52)
Display Units - Set UN (86)
Event - Configure ESET(1) (3738)
Event Acknowledged - Show EACK (3225)
Event List - Show ELIST (35478)
Machine Location - Show LOC (562)
Machine Status - Show MSTAT (67828)
Resettable Totals - Reset RESET (73738)
Resettable Totals - Show TOT (868)
System Self Test TEST (8378)
Truck Payload - Calibrate PAYCAL(1) (729225)
Truck Payload - Configure PAYCONF(1) (7292663)
(1) The VIMS service tool is required to be connected and communicating with the machine before this Service Program Code will function.Each service program code is a unique number of one to ten digits that abbreviates this operation. The service program codes have a letter equivalent that describes the service operation. This letter equivalent makes remembering the service program code for each operation easier. The English letter equivalent for each service program code is shown in the parentheses. The same service program codes are used regardless of the onboard language. After you enter the service program code on the keypad, the request will begin after you press the "OK" key. You must activate this command within five seconds of entering the last SPC character. The maximum delay that is allowed between the entry of the SPC characters is five seconds.