HOUSING 2G0928 - Caterpillar

Transmission
Table 2
793F Caterpillar Power Shift Transmission
Travel Speeds at 1900 RPM
Transmission Gear Speed
1 12.9 km/h (8 mph)
2 17.4 km/h (10.8 mph)
3 23.8 km/h (14.8 mph)
4 32.1 km/h (19.9 mph)
5 43.6 km/h (27.1 mph)
6 60 km/h (37.3 mph)
R 11.8 km/h (7.3 mph) Dimensions
Illustration 1 g06145537
Dimensions reflect an MSD II body. All dimensions are approximate. Dimensions will vary depending on the configuration and the options.
(A) Overall Width 830 cm (27 ft 3 inch)
(B) Overall Tire Width 761 cm (24 ft 11 inch)
(C) Overall Height (body down and empty) 651 cm (21 ft 4 inch)
(D) Overall Length 1370 cm (44 ft 11 inch)
(E) Loading Height (body empty) 653 cm (21 ft 5 inch)
(F) Overall Height (body raised) 1388 cm (45 ft 6 inch)
(G) Wheel Base 591 cm (19 ft 5 inch)Weights
The target gross machine operating weight is listed under "Application/Configuration Restrictions" (see below).The empty machine weight of the 793F will depend on the configuration of the machine. Weigh the empty machine to get an accurate weight. If a suitable scale is not available, contact your local Caterpillar dealer for an approximate weight of the machine, as equipped when shipped from the factory. This weight will not include extra equipment or options that have been installed on the machine after leaving the factory.The target payload depends on the machine configuration. To calculate the target payload, subtract empty machine weight from the target gross machine operating weight.The Caterpillar payload overload policy, referred to as the 10/10/20 Overload Policy, states that no more than 10% of payloads may exceed 110% of the target payload, and no single payload shall ever exceed 120% of the maximum target payload.If this machine has a "CE" plate that is required for the European Union, the weight on the "CE" plate is based on the following:
Empty machine weight with a flat floor body and high impact liner
Full tank of fuel
75 kg (165 lb) operatorIn certain environments, where excessive mud or debris accumulation is common on the machine, extra weight should be calculated into the empty machine weight to calculate the target payload. Consult your local Cat dealer for more information.Intended Use
The 793F Off-Highway Truck is an earthmoving machine. The 793F is classified as a dumper as described in ISO 6165:2006. This machine is a self-propelled wheeled machine with a rigid frame and wheel steering. This dumper has an open body that is intended for the following applications: transporting loose material and dumping loose materialAny modifications made to the body should be pre-approved by your local Cat dealer.Useful Life
The useful life of this machine is dependent upon many factors including the machine owner’s desire to rebuild the machine back to factory specifications. Consult your Cat dealer for assistance in calculating overall owning and operating costs required to determine the machines useful life. The following items are required to obtain an economical useful life of this machine:
Perform regular preventive maintenance procedures as described in the Operation