HOUSING ASSEM. 2N2045 - Caterpillar

Start By:
Remove the winch motor. Refer to Disassembly and Assembly, "Winch Motor - Remove".
Illustration 1 g01270183
Remove bolts (1) and head (2).
Illustration 2 g01270184
Remove port plate (3).
Illustration 3 g01270185
Remove nut (5) and coil (4).
Illustration 4 g01270186
Remove cartridge (6).
Illustration 5 g01270187
Remove plug (7) and the O-ring seal.
Illustration 6 g01270188
Remove piston (8).
Illustration 7 g01270571
Illustration 8 g01270573
Remove cap (9).
Use a depth gauge to measure the distance between the end of screw (13) and locknut (12). Record this measurement for assembly purposes.
Remove locknut (12) and screw (13).
Remove plug (10) and the O-ring seal.
Remove plug (11) and the O-ring seal.
Illustration 9 g01270575
Remove barrel (14).
Remove O-ring seal (15) from housing (16).
Illustration 10 g01270576
Remove spring (17) and shim (18) from barrel (14).
Illustration 11 g01270577
Use Tooling (A) to remove retaining ring (19).
Remove spacer (20) and rotating group (21).
Illustration 12 g01270579
Remove seal (22).
Illustration 13 g01270580
Remove bolts (23), pistons (24), center pin (25), and retainer plate (26).
Illustration 14 g01270608
Use Tooling (C) to remove retaining ring (27).
Remove shim (28).
Illustration 15 g01270609
Place the rotor assembly in a suitable press. Use Tooling (B) to remove shaft (29) from bearing cone (30), bearing cup (31), shim (32), bearing cup (33), and bearing cone (34).