HOUSING-COUPLER 2V2102 - Caterpillar

Illustration 1 g02808536
Schematic of the start relay magnetic switchThis diagnostic code is associated with the start relay magnetic switch. The FMI 03 means that the Electronic Control Module (ECM) has determined that the voltage of the relay circuit is above normal.The possible causes of the diagnostic code are:
The relay has failed
The relay circuit is shorted to the +battery circuit
The ECM has failed. The ECM is unlikely to failNote: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0444 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active, the ECM will turn off the current to the failed relay.Test Step 1. CHECK THE RELAY CIRCUIT FOR A SHORT TO THE +BATTERY CIRCUIT
Move the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the relay and the ECM.
At the machine harness connector for the ECM, measure the resistance from contact J2-7 (wire 306-GN) to all contacts that are used in the machine harness connectors for the ECM.Note: The suppressor harness is polarity sensitive.Expected Result:Each resistance measurement is greater than 5 ohms.Results:
YES - Each resistance measurement is greater than 5 ohms. The machine harness is correct. Proceed to Test Step 2.
NO - One or more resistance measurements are less than 5 ohms. There is a short in the machine harness. The short is between J2-7 (306-GN) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Move the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if CID 0444 FMI 03 is active.Expected Result:CID 0444 FMI 03 is active.Results:
YES - CID 0444 FMI 03 is active. The problem has not been corrected. The ECM may have failed.Repair: The ECM is unlikely to have failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. Refer to Troubleshooting, Testing, and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NO - CID 0444 FMI 03 is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by:
A poor electrical connection
A short at one of the harness connectors that was disconnected and reconnectedResume normal machine operation.STOP