HOUSING GP-FLYWHEEL 3062313 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
1 5137583 TUBE
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 1% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Perform the Rework Procedure only if the grease tube is damaged. The existing nipples, washer, and grease zerk will be reused for the replacement.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-20000 hrs,
0-60 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Grease tube Hardware components:
Image1.1.1
1. Remove the screws securing the two clamps (1) holding the tube to the bracket. (see Image 1.2.1)
2. Using locking pliers, lock one pair inside the generator barrel on the coupling to hold, lock the other pair on the coupling located outside the generator barrel and remove. (see Image 1.2.2 and Image 1.2.3)
3. Remove the tube from the generator barrel being careful not to drop the washer located between the inner coupling and the generator barrel. (see Image 1.2.4 and Image 1.1.1)
4. Remove the tube from the bearing housing (2). (see Image 1.2.1)
Image1.2.1
Image1.2.2
Image1.2.3
Image1.2.4
5. Remove the 1/8" coupling, 1/8" pipe nipple and washer from the existing tube.
6. Re-install the components removed in step 5 to the new hose.
7. Pre-load the new grease tube with grease (this is an important step).
8. Install the new tube in the bearing housing. (see Image 1.3.1)
9. Install the other end of the new tube through the generator shell and place the 1/8" coupling on the outside of the shell to hold in place (see Image 1.2.4).
10. Repeat step 2 above to tighten the tube in place. When tightening the tube, position the tube so that it does not come in contact with the non-drive end bracket at any location.
11. Do not reinstall the clamps securing the tube to the non-drive end bracket.
Image1.3.1