HOUSING GP-FLY 3254375 - Caterpillar

Illustration 4 g06228728
Ensure that the rotor system is deactivated. Indicator light next to the button should be off. If the rotor system is operating, push rotor button (6) to deactivate.
Illustration 5 g06228737
Use conveyor buttons (7) to center the conveyor.
Use propel lever (1) to center the front tracks.
Illustration 6 g06229133
Observe level indicator (8). If the indicator shows "0" go to Step 12. If the indicator does not show "0", go to Step 11.
Illustration 7 g06229150
Use rear leg height switches (9) and (10) to level the rear of the machine. Level indicator (8) will show "0" when the rear of the machine is level. Make sure that the rotor does not contact the ground during this step.
Illustration 8 g06229152
Ensure that the engine is operating in low idle. The high idle indicator light should be off. If this indicator is illuminated, press throttle control button (11) to operate the engine in low idle.
Illustration 9 g06229156
Move engine start switch (12) to the OFF position.
Illustration 10 g06229157
Unhook latch (13). Open left compartment door (14), and install the door prop.
Illustration 11 g06229182
Remove cap (16), and connect one Tool (A2) to the pressure tap in port "MB" (15).Test Procedure
Move engine start switch (12) to the START position. Release the switch when the engine starts.
Illustration 12 g06233061
Use travel mode button (17) to set the machine to working mode. The indicator next to the button will not be illuminated when the machine is in the working mode.
Use throttle control button (11) to operate the engine in high idle.
Illustration 13 g06241132
Monitor the hydraulic oil temperature on operator display (18). Operate the machine until the oil temperature reaches the test temperature listed in the "Specifications" section.
Illustration 14 g06230810
Press interlock button (19), and slowly move propel lever (1) into the FULL FORWARD position.
Allow the pressure to stabilize. Read the pressure shown on Tool (A) at port "MB" (15). Refer to the "Specifications" section for the target pressure at port "MB".
Illustration 15 g06233064
Press "Traction Control" button (20) to engage the traction control. Read the pressure shown on Tool (A) at port "MB" (15). Refer to the "Specifications" section for the target pressure with the traction control activated. If the pressure increase is out of specification, go to the "Adjustment Procedure".
Move propel lever (1) into the NEUTRAL position to place the machine in neutral. Release the propel lever.
Use throttle control button (17) to operate the engine in low idle.
Move engine start switch (12) to the OFF position.
Compare the recorded pressure readings to the pressure specifications listed in the "Specifications" section. If either pressure reading did not increase in Step 7, perform the "Adjustment Procedure". If the pressure readings are inside the specified range, go to the next step.
Remove Tool (A2) form the pressure tap in port "MB" (15). and install cap (16).
Release the door prop, and close left compartment door (14). Secure the door with latch (13).Adjustment Procedure
Repair or replace the flow divider valve.
Perform the "Test Procedure".