HOUSING GP-ECCENTRIC WEIGHT 3474214 - Caterpillar

No Clearance
Illustration 5 g00284615
This warning label is positioned on the hitch link.
g00100418
Hitch and steering movement can reduce clearances suddenly and cause personal injury...Stop engine before servicing.
Improper Connections For Jump Start Cables
Illustration 6 g00667339
This warning label is positioned next to the battery compartment of the tractor.
g00667533
There is limited battery access. Jump starting at the battery, or improper jumper cable connections at the starter, can cause explosion resulting in personal injury.Do not jump start the machine at the battery. Use the remote starting receptacle or jump start to the positive battery post on the starter.If remote starting receptacle can not be used, jumper cables may be used at the starter. Always connect the positive (+) cable to positive (+) terminal of the starter and connect negative (-) cable from external source to engine block. Follow procedure from the Operation and Maintenance Manual.
High Pressure Cylinder
Illustration 7 g00284610
This warning label is positioned on all accumulator cylinders.
g00100419
High pressure cylinder:Do not remove any valve, hydraulic fitting, or valve core, nor disassemble any parts until pressure has been relieved or personal injury may occur.To relieve pressure:1. Shut off engine and wait five minutes for hydraulic system pressure to dissipate.2. Relieve gas pressure in the accumulator cylinder by opening the charging valve one turn only.See your Caterpillar dealer for tools and detailed information required for charging cylinders.Charge cylinder with dry nitrogen gas.
Block The Apron
Illustration 8 g00284616
This warning label is positioned on the side of the bowl.
g00100420
BLOCK THE APRON UP WHEN MAINTENANCE REQUIRES THE APRON TO BE OPEN.Apron movement can cause serious injury unless these steps are taken.
Place the apron in the up position.
Stop the engine.
Move the disconnect switch to off and remove the key.
Place a Do Not Operate tag on the steering wheel.
Remove the retaining bolt (A).
Remove the pin (B). Storage opposite end some models.
Install the pin (B) in position (C).
Install the retaining bolt (A).
Lower the apron on to the pin (B).
Engine Coolant
Illustration 9 g00715967
This warning label is positioned on the top of the radiator tank.
g00576688The coolant is under pressure. Also, the coolant is hot. Do not touch the hot surfaces. Refer to the Operation and Maintenance Manual for the procedure to follow when you check the radiator.