HOUSING-FLYWHEEL 3990929 - Caterpillar

To prevent personal injury when checks are made while the machine is in operation, make sure only approved personnel are on the machine. Keep other personnel off the machine and in view of the operator. Make sure checks are done in an open area.
Table 1
Required Part    
Part Number     Description     Quantity    
8T-0861 (1)     Pressure Gauge     1    
( 1 ) Part of 4C-4892 ORFS Fittings Group
Block the drive wheels in both directions.
Assemble the 8T-0861 Pressure Gauge with the proper fittings from 4C-4892 ORFS Fittings Group .
Illustration 1 g00762280
(1) Reverse main relief valve test port (2) Forward main relief valve test port (3) Forward multifunction valve
Attach the pressure gauge to forward test port (2) .
Set the load controller in the MANUAL position.
Engage the parking brake.
Start the engine and place the machine in fourth gear. Run the engine at high idle.
Illustration 2 g00762282
(4) Electrical displacement control (EDC)
Stroke the propel pump by moving the manual control lever on top of electrical displacement control (EDC) (4). Read the pressure gauge. The forward main relief valve setting should be 46195 1380 kPa (6700 200 psi).
If the pressure reading for the forward main relief valve setting is not correct, adjustment is necessary. Slow the engine to low idle, and put the machine in neutral.
Remove the plastic dust plug from forward multifunction valve (3). Insert a 5 mm internal hex wrench in the adjustment screw and loosen the locknut (smallest hex on the multifunction valve).
Turn the adjustment screw clockwise or counterclockwise in order to obtain the correct pressure reading.Note: One turn of the adjustment screw changes the pressure reading by approximately 9300 kPa (1350 psi).
After an adjustment has been made, repeat Step 8 and Step 9 in order to recheck the forward main relief valve pressure reading.
When the