HOUSING-SCREEN 3P8186 - Caterpillar

Illustration 1 g03049539
(A) Shutoff position is 8.5 degrees
(B) Fuel-on position is 32 degrees
(C) Shutoff position is 30 5 degrees
Table 1
Specification for 150-4146 Fuel Injection Pump Fastener
Item Qty Part Specification Description
1 1 4W-5029 Lever As Diameter of the shaft is 19.050 0.013 mm (0.7500 0.0005 inch).
2 2 8L-6376 Bushing Bore in bearing after assembly in the bracket is 19.126 0.038 mm (0.7529 0.0015 inch).
6 1 6V-8186 Full Nut Torque to 12 4 N m (106 35 lb in).
8 4 5L-3708 Taperlock Stud Torque to 17 5 N m (151 44 lb in).
- - - Use the following procedure in order to adjust the linkage:
Install lever (3) with the control linkage in the shutoff position against the stop.
Lever (8) must be installed at the angle that is shown with the actuator lever in the shutoff position against the stop.
With lever (3) and lever (8) in the shutoff position, adjust rod end (4) and rod assembly (6) to the needed length. Tighten nuts (5) in order to hold the rod ends in position.
The threads of rod end (4) must be visible through the holes in the rods in order to make sure that there is minimum thread engagement.
Connect lever (3) and lever (8) together with rod assembly (6).