HOUSING-MOTOR 4523522 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5F-4764     Pry Bar     1    Start By:
Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Illustration 1 g01021163
Remove nuts (1). Remove the washers and bolts (2) that hold crankshaft rear seal carrier (3) to the cylinder block.
Use Tooling (A) to carefully pry crankshaft rear seal carrier (3) from the crankshaft.
Remove the gasket between the cylinder block and crankshaft rear seal carrier (3) .Installation Procedure
Illustration 2 g01028714
Place a new gasket over dowels (4) .
Illustration 3 g01021163
Place crankshaft rear seal carrier (3) on the crankshaft.
Install nuts (1). Install the washers and bolts (2) .End By: Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".